Clipper with an adjustable lever
Does the bulk removal and most of the blending. Opening and closing the lever creates in-between lengths that soften the jump from one guard to the next.
Technique · Fades · 2026
To cut a skin fade, set a clean, level guideline, take everything below it down to bare skin with a trimmer or foil shaver, then work upward through your guards from shortest to longest. Most of the time goes into blending the narrow band where skin turns into shadow, using the clipper lever and light, flicking strokes until no line shows.
Start with the shape
A skin fade (also called a bald fade) is a fade whose shortest point is bare skin. Where the fade starts on the head decides whether it's low, mid or high.
A low skin fade sits just above the ear and follows the hairline around the back. A mid fade starts around the temple. A high fade climbs toward the parietal ridge, the widest part of the head, and shows a lot of skin. The steps are the same for all three; only the guideline height and the room you have to blend change.
"The clippers remove the hair. The blending is the haircut."
Before the first pass
Does the bulk removal and most of the blending. Opening and closing the lever creates in-between lengths that soften the jump from one guard to the next.
A typical skin fade uses the short end of the set: 0.5, 1, 1.5, 2 and sometimes 3. Snap guards on firmly; a loose guard is how accidental bald spots happen.
Sets the guideline, takes the bottom close to skin, cleans the neckline and sharpens the lineup. Used open-blade, it also erases small dark spots in the blend.
Takes the bottom to true skin, smoother than a trimmer can. Our beginner barber tool kit guide explains why many students add it once their fades are already clean.
The sequence
Barbers vary the details, but the logic stays the same: set the shape, remove bulk, take it to skin, then blend until the lines disappear.
Ask where the fade should sit and how long the top stays. Check cowlicks, head shape, scars and growth direction before you cut.
Take the sides and back down with a longer guard (often a 2 or 3) so you're working on an even surface.
With the trimmer or an unguarded clipper, cut a clean line where the fade will begin. Check it from every side, using the ears and occipital bone as landmarks.
Below the line, remove everything with the trimmer, then the foil shaver. Stretch the skin gently and keep pressure light. Pushing harder doesn't cut closer; it irritates the skin.
Work upward, each longer guard going a little higher than the last: 0.5, then 1, then 1.5. Flick the clipper away from the head as you rise so each length fades into the next instead of leaving a shelf.
The hardest part. Work the strip just above the skin with the lever half open, the trimmer open-blade or a very short guard, in short, light strokes. Brush away clippings often and check in good light.
Use your longest guard, clipper-over-comb or scissor-over-comb to remove any weight line so the sides and top read as one haircut.
Finish the hairline, temples, ears and neckline with the trimmer or a straight razor. Check every angle in the mirror and fix dark spots before the client leaves.
What goes wrong
One side sits higher, or the line dips behind the ear. Check it from the front and in the mirror, not only from the side.
You can't put hair back. Start low and creep upward; you can always take more off.
Visible steps come from straight up-and-down passes. The fix is the flick-out motion and lever work, not more pressure.
Spend your time on the blend, and use sharp blades, light pressure and fewer passes to avoid irritation.
Getting good
A skin fade is a hand skill, and hand skills come from repetitions with feedback. Videos teach the sequence, but real heads have cowlicks, scars and every texture.
That's how barber school is built. At American Barber Institute, students start with sanitation, tool control, guards and sectioning on mannequins, then move to a supervised clinic floor where they cut real clients while a licensed instructor watches and corrects. Low, mid and high fades are among the services offered there, so students practice on a wide range of hair types. See how the student clinic works and the skills you learn in barber school.
"Clean first, consistent second, fast third."
Speed comes later, and more clean fades per day is part of how barbers build their income.
The path to a license
New York's barber license requires training at an approved barber school (or a two-year registered apprenticeship), passing the NYS practical examination, and a one-time Transmission of Contagious Diseases course. The official steps are on the NY Department of State "Become a Barber" page.
The practical exam judges sanitation and safe technique as much as the haircut. Read how to pass the New York State Board exam to see what examiners look for.
Straight answers
A regular fade usually stops at a short guard length, so a little hair stays at the bottom. A skin fade goes all the way to bare skin, which makes the skin-to-shadow transition more visible and the blend harder to hide.
A common progression is skin at the bottom, then 0.5, 1, 1.5 and 2 working upward, with the clipper lever creating in-between lengths. There's no single correct set; the goal is a smooth gradient with no visible lines.
No. A trimmer can take the bottom very close to skin. A foil shaver gives a smoother, truly bare finish, so most barbers add one once their basic fades are clean.
Lines usually come from straight up-and-down passes or jumping too far between guards. Use a flicking motion, add in-between lengths with the lever, brush away clippings and check the blend in good light.
Yes. At American Barber Institute, low, mid, high and skin fades are a core part of the 500-hour Master Barber program. Students learn fundamentals first, then cut real clients under licensed instructors at the Manhattan and Bronx clinic floors.
Read next
What a new barber actually needs, and what can wait.
Why cutting every hair type on a real clinic floor makes you more hireable.
What the practical exam checks, and the sanitation habits that decide most results.
Learn it on real clients
Schedule a tour of our Manhattan or Bronx campus, see the clinic floor, and ask admissions about the next start date. Prefer to talk? Call (212) 290-2289.
Classes begin the first Monday of each month
Next class starts soon. Seats fill fast — start your barber school enrollment, request a call, or speak with admissions in English or Spanish.